环氧沥青厚膜型涂料的用途.doc

环氧沥青厚膜型涂料的用途
IntendedUses
用途用于船底,压载水舱,污水及其他恶劣环境中的钢铁长期保护,也适用于码头,石油,铁井平薹,港口闸门,矿井支架,管道等钢铁或混凝土等作防腐涂料,有优良的防腐性能,漆膜坚韧,物理机械性能佳,附着力强.
Providealong-termprotectiononshipbottom,ballasttank,sewagetankandothersteelinseverelycorrosiveconditions.Itisalsoappliedonsteelorconcreteofwharf,petroleumdrillingplatform,port,sluicegate,mineshaftsupport,pipeetcasanti-corrosivepaint,Itformsatoughcoatingwithexcellentcorrosionresistance,physicalandmechanicalproperties,goodadhesion.Product
Description
产品简介底漆:棕色;面漆:黑色,双罐装,乙组份为底漆和面漆均通用的固化剂
Primer:brown;Finish:black.Twopackages.ComponentBisuniversalcuringagentforprimerorfinish.Product
Information
产品数据VolumeSolids固体份≥65%DryFilmThickness干膜厚度125micronsequivalentto192micronsofwetfilm
125微米相当于192微米湿膜厚TheoreticalCoverage理论涂布率4.3m2/Kg4.3平方米/公斤PracticalCoverage实际涂布率Allowappropriateloss允许适量损耗ApplicationDetails
施工详述
MixRadio混合比A:B=9:1(byweight)甲:乙=9:1(重量比)MethodofApplication施工方法
AirlessSpray无空气喷涂Recommended推荐采用

BrushorRoller涂刷或辊涂Recommended推荐采用

ConventionalSpray传统喷涂NotRecommended不推荐采用Thinner稀释剂C003Cleaner油漆设备清洗剂C003PotLife使用期25℃:6h(小时)30℃:4h(小时)Storage贮存期Oneyear一年Dryingtime
干燥时间
Substrate
Temperature
底材温度TouchDry
表干
（h）HardDry
硬干
（h）OvercoatingInterval
覆涂间隔Mix最短Max最长20℃
30℃4
248
1642hours小时
16hours小时5days(天)
2days(天)
Storageand
Handling
贮存与管理SpecificGravity比重Approx1.2Kg/L大约1.2公斤/公升Packsize包装规格A;18Kgin20litercontainer甲:18公斤装于20公升容器中
B:2Kgin4litercontainer乙:2公斤装于4公升容器中FlashPoint闪点Primer(底漆):22℃Finish(面漆):21℃
Limitations
限制Recommendcost:Sprayonecoatofprimerandonecoatoffinishwithhigh-pressurearilesssprayforsakeof250micronsofdryfilmthickness.
Precedingcoat:Epoxyzincrichshopprimer,epoxyzincdustprimer,inorganiczincsilicateprimer,micaceousironoxideepoxyanti-corrosionpaintetc.AlsobepainteddirectlyonsurfacetreatedtoSa2.5.
推荐涂装道数：高压无空气喷涂底，面漆各一道，干膜厚度达到250微米。
前道配套涂料：环氧富锌车间底漆，环氧锌粉底漆，无机硅酸锌底漆，环氧云铁防锈漆等等，也可直接在防锈质量达到Sa2.5级的钢材表面涂漆。

Safety
Precautions
安全措施Theproductmustbeusedinpaintingareabyprofessionals.Whenpainting,pleasebesuretorefertoProductDataSheetandM