H3C MSR 930 系统固件恢复.docx

H3CMSR930系统恢复
1配置计算机IP地址并关闭系统防火墙
将计算机的IP地址更改为192.，关闭系统防火墙。
2安装配置TFTP软件
安装3com的tftp软件，并安装下图位置进行配置。

将H3CMSR930路由器的系统固件放到TFTP服务器的指定目录。

3检查串口设备，并做相应的设置。
按照下图设置COM接口。

4启用SecretCRT，选择串口连接

5线路连接
Consol线连接电脑串口，电脑网线连接路由器的GE0口（WAN）
6以下是设备升级的具体操作

Systemisstarting...
PressCtrl+DtoaccessBASIC-BOOTWAREMENU
DoyouwanttocheckSDRAM?[Y/N]
BootingNormalExtendBootWare
TheExtendBootWareisself-decompressing.........................Done!

****************************************************************************
**
*H3CMSR930BootWare,Version5.10*
**
****************************************************************************
Copyright(c)2004-2015HangzhouH3CTechnologiesCo.,Ltd.

CompiledDate:Dec212015
CPUType:P1010
CPUL1Cache:32KB
CPUL2Cache:256KB
CPUClockSpeed:533MHz
MemoryType:DDR3SDRAM
MemorySize:256MB
MemorySpeed:667MHz
BootWareSize:1024KB
FlashSize:128MB
CPLDVersion:1.0
PCBVersion:3.0

BootWareValidating...
Applicationprogramdoesnotexist.
BootWarepassword:Notrequired.PleasepressEntertocontinue.

Passwordrecoverycapabilityisenabled.
Note:Thecurrentoperatingdeviceisflash
Enter<StorageDeviceOperation>toselectdevice.

===========================<EXTEND-BOOTWAREMENU>===========================
|<1>BootSystem|
|<2>EnterSerialSubMenu|
|<3>EnterEthernetSubMenu|
|<4>FileControl|
|<5>RestoretoFactoryDefaultConfiguration|
|<6>SkipCurrentSystemConfiguration|
|<7>BootWareOperationMenu|
|<8>ClearSuperPassword|
|<9>StorageDeviceOperation|
|<0>Reboot|
============================================================================
Ctrl+Z:AccessEXTEND-ASSISTANTMENU
Ctrl+F:FormatFileSystem
Ctrl+C:DisplayCopyright
Enteryourchoice(0-9):3进入以太网子菜单

==========================<EnterEthernetSubMenu>==========================
|Note:theoperatingdeviceisflash|
|<1>DownloadApplicationProgramToSDRAMAndRun|
|<2>UpdateMainApplicationFile|
|<3>UpdateBackupApplicationFile|
|<4>UpdateSecureApplicationFile|
|<5>ModifyEthernetParameter|
|<0>ExitToMainMenu|
|<EnsureTheParameterBeModifiedBeforeDownloading!>|
==========